Description
Cristec DC-36-36/40PL DC-DC converter charger
Cristec DC-36-36/40PL is a DC POWER+ DC-DC converter charger rated for a 36VDC source, 36VDC output and 40A rated output current. The exact 36-to-36V / 40A configuration is identified in Cristec’s 2026 technical catalogue. It is intended to be selected as part of the complete DC charging system, so the source supply, destination battery bank, cable sizes, protection and battery settings all need to be checked before installation.
36VDC to 36VDC, 40A configuration
The model code and current Cristec catalogue identify this version as 36VDC to 36VDC at 40A. It is therefore a higher-current 36V-to-36V version and should be matched to the actual source and destination systems. Confirm the nominal source voltage, destination battery voltage and required charge current before wiring. On a refit, record the previous charger’s model, cable sizes, fusing and connection arrangement before removal so that unsuitable legacy wiring is not automatically reused.
Battery bank and charging settings
If the output is charging a battery bank, identify the battery chemistry, capacity and manufacturer’s permitted charging limits. Lead-acid and lithium systems can require different settings and protection arrangements. Where a battery-management system is fitted, its current limits and charge-disconnect behaviour must also be considered. Other charging sources connected to the same bank should be reviewed so that the combined charging arrangement remains suitable for the batteries installed.
Cable sizing, isolation and protection
A 40A output circuit and its source wiring require appropriately sized conductors, secure terminations and correctly rated protective devices. Cable size must account for current, route length and acceptable voltage drop. Inspect existing lugs, busbars, fuse holders and isolators for corrosion, heat damage or looseness before reusing them. Protect positive conductors from accidental short circuit, support heavy cables mechanically and keep cable routes away from heat, sharp edges and water where practical.
Mounting and service access
Install the converter in the orientation and environment specified by Cristec, with the required ventilation and access to terminals, indicators and configuration points. Avoid locations exposed to spray, excessive heat or mechanical damage. If replacing older equipment, compare dimensions and cable-entry positions before altering the mounting surface. Leave enough service access for future inspection and testing.
Commissioning checks
Before energising, verify polarity, source voltage, destination-bank voltage, protection and terminal security. Confirm the battery configuration and then check operation under realistic charging conditions. Measure voltage at the source, converter and destination bank so excessive cable drop can be identified. Check for alarms, abnormal heating and secure operation with other charging sources and normal vessel loads. Record the installed model, settings and circuit protection for future service.
Documentation and related guidance
For current manufacturer data, see Cristec marine electrical products. The current Cristec DC POWER+ manual and catalogue should be the final reference for ratings, charging settings, wiring, protection and mounting. F&C Marine also provides a Marine Electronics Knowledge Base with practical marine electrical guidance.
Official manuals, datasheets and brochures
Related products
- Cristec DC-36-36/20PL – 36VDC-36VDC-20A
- Cristec DC-36-48/15PL – 36VDC-48VDC-15A
- Cristec DC-36-24/30PL – 36VDC-24VDC-30A
Related technical resources
Before ordering Cristec DC-36-36/40PL
Send F&C Marine the vessel type, source-system details, destination battery voltage, chemistry and capacity, existing charger model, cable lengths and photographs of the installation. If this is a fault replacement, include symptoms and measurements. We can then confirm that the 36VDC-to-36VDC 40A version is the correct model and identify likely installation requirements before quotation.
Reviews
There are no reviews yet.