Koden TD-2001D – Rubber 1kW 200kHz 9m cable

£544.00 ex. VAT

Koden TD-2001D rubber 1 kW 200 kHz transducer with 9m cable. Contact F&C Marine for sounder compatibility and installation support.

SKU: TD-2001D Category: Brand:

Description

Koden TD-2001D marine transducer

Koden TD-2001D is a rubber 1 kW transducer listed for 200 kHz operation and supplied with a 9m cable. Correct transducer selection depends on the echo sounder, frequency and power requirements, mounting arrangement and vessel hull. F&C Marine can help confirm compatibility and installation details before the TD-2001D is ordered or used to replace an existing sensor.

Koden TD-2001D

Frequency and sounder matching

This model is listed for 200 kHz operation at 1 kW. The connected sounder must support the appropriate transducer characteristics; a mechanically similar unit is not automatically electrically compatible. When replacing an existing transducer, record the sounder model, old transducer reference, connector and cable arrangement. If the sounder has selectable transducer settings, configuration should be checked against current Koden documentation during commissioning.

Mounting and acoustic performance

Transducer position has a major effect on performance. The acoustic face needs a clear path into the water and should be away from turbulence, aerated flow and hull structures likely to disturb the signal. Consider strakes, steps, propellers, thrusters and nearby fittings when choosing the mounting location. If the transducer is being fitted into an existing housing, fairing or tank, inspect that installation and confirm it is suitable before committing to the replacement.

Cable routing and protection

The 9m transducer cable should be protected from sharp edges, crushing, heat and avoidable electrical interference. Avoid tight bends and unsupported strain at the connector. Do not shorten, extend or alter the transducer lead unless manufacturer instructions permit the exact method being used. Keep connectors dry and accessible for future testing. Plan bulkhead penetrations and cable protection before installation so the lead is not damaged while being routed through machinery spaces or structural areas.

Commissioning and fault finding

After installation, confirm the echo sounder detects the transducer and produces stable depth information. Test with other vessel machinery running because electrical noise can appear only under operating conditions. Where practical, check performance while moving, since aerated water and turbulence can cause loss of bottom. If the TD-2001D is replacing a suspected failed transducer, inspect the old connector and cable path first so a wiring defect is not carried into the new installation.

Documentation and related guidance

For manufacturer information, see Koden marine electronics. Relevant Koden documentation should be the final reference for sounder compatibility, mounting and cable handling. You can also browse F&C Marine echo sounders and transducers and our Marine Electronics Knowledge Base.

Official manuals, datasheets and brochures


Related products


Related technical resources

Before ordering Koden TD-2001D

Send the vessel type, mounting arrangement, echo sounder model, existing transducer details, photographs and approximate cable run. If this is a fault replacement, include symptoms and tests already completed. F&C Marine can then help confirm whether TD-2001D is the correct 200 kHz 1 kW transducer and identify installation considerations before work begins. Correct matching at this stage can avoid unnecessary hull work and commissioning delays.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.