Description
Koden TD-284A marine transducer
Koden TD-284A is a rubber through-hull transducer listed for 28 kHz operation at 3 kW. Correct transducer selection depends on the connected sounder, frequency and power requirements, mounting arrangement and vessel hull. F&C Marine can help confirm whether TD-284A is compatible with the sounder and installation before equipment is ordered.

Frequency, power and sounder matching
This model is listed for 28 kHz operation at 3 kW. The sounder must support the appropriate transducer characteristics; a mechanically similar sensor is not automatically electrically compatible. When replacing an existing transducer, record the sounder model, previous transducer reference, connector and cable arrangement. Configure any selectable transducer settings using current Koden documentation rather than relying on settings from earlier equipment.
Through-hull mounting and acoustic performance
A through-hull transducer requires a clear acoustic path and clean water flow. Avoid positions affected by turbulence or aerated water from hull steps, strakes, propellers, thrusters and nearby fittings. The mounting arrangement needs to suit the vessel and transducer housing. If an existing fairing, tank or through-hull opening is to be reused, inspect it and confirm the position remains suitable before fitting the replacement sensor.
Cable routing and protection
Protect transducer cabling from sharp edges, crushing, heat and unnecessary electrical interference. Avoid tight bends and unsupported strain at connectors. Do not shorten, extend or alter the transducer lead unless manufacturer documentation permits the exact method. Keep plugs dry and accessible for future testing. Plan cable routes and bulkhead penetrations before installation so the lead is not damaged while being pulled through machinery spaces or structural areas.
Commissioning and fault finding
After installation, confirm that the sounder detects the transducer and produces stable depth or target information. Test with other vessel machinery running because electrical noise may only appear under operating conditions. Where practical, check performance underway because aerated water and turbulence can cause loss of bottom. If TD-284A is replacing a suspected failed transducer, inspect the old connector and cable path first so a wiring defect is not carried into the new installation.
Documentation and related guidance
For manufacturer information, see Koden marine electronics. Relevant Koden documentation should be the final reference for sounder compatibility, mounting and cable handling. You can also browse F&C Marine echo sounders and transducers and our Marine Electronics Knowledge Base.
Official manuals, datasheets and brochures
Related products
- Koden NGM100-200-12L – Rubber 2kW 200kHz
- Koden TD361K – Rubber 38 – 70kHz @ 2kW & 130 – 210kHz @ 1kW
- Koden TD-340K – Rubber 1kW 38-70kHz & 130 – 220kHz
Related technical resources
Before ordering Koden TD-284A
Send the vessel type, mounting arrangement, echo sounder model, existing transducer details, photographs and approximate cable run. If this is a fault replacement, include symptoms and tests already completed. F&C Marine can then help confirm whether TD-284A is the correct 28 kHz 3 kW transducer and identify installation considerations before work begins. Correct matching can avoid unnecessary hull work and commissioning delays.















Reviews
There are no reviews yet.