Description
Koden TD-501C+AC marine transducer
Koden TD-501C+AC is a rubber-moulded 1 kW 50/200 kHz transducer package listed with a CW-840-0.3m connection cable. Correct transducer choice depends on the echo sounder, mounting method, hull arrangement and intended operating requirement. F&C Marine can help confirm whether this package is compatible with the sounder and installation before equipment is ordered.

Frequency, power and sounder matching
This configuration is listed for dual-frequency 50/200 kHz operation at 1 kW. Frequency and power capability need to match the connected sounder; similar-looking transducers may have different electrical characteristics. When replacing an existing transducer, record the sounder model, old transducer reference, connector and cable arrangement. If the sounder offers selectable transducer settings, configuration should be checked against the applicable Koden documentation during commissioning.
Mounting and acoustic performance
Transducer performance is strongly influenced by position and installation method. The acoustic face needs a clear path into the water and should be kept away from turbulence, aerated flow and structures that can interrupt the signal. The exact mounting arrangement should suit the vessel and the rubber-moulded transducer housing. Before modifying an existing installation, inspect the mount, fairing or tank arrangement and confirm that the replacement transducer can be installed without compromising the hull or acoustic path.
Cable routing and connections
The transducer and CW-840-0.3m connection arrangement should be routed and connected in accordance with the manufacturer documentation. Avoid tight bends, crushing and unsupported loads on plugs. Protect connectors from moisture and keep them accessible for testing. Transducer cabling should not be cut, lengthened or altered unless the manufacturer permits the method used. If the route passes through machinery spaces or bulkheads, plan cable protection and penetrations before installation to reduce the chance of hidden damage.
Commissioning and fault finding
After installation, confirm the sounder recognises the transducer and produces stable depth information. Test with other machinery operating because electrical interference can be absent during a quiet berth test. Where practical, check the system while the vessel is moving, since turbulence over the transducer can cause unstable readings or loss of bottom. If the change is being made because of a fault, inspect the old cable and connector as well as the transducer so a wiring problem is not mistaken for a failed sensor.
Documentation and related guidance
For manufacturer information, see Koden marine electronics. Use relevant Koden documentation as the final reference for compatible sounders, mounting and wiring. You can also browse F&C Marine echo sounders and transducers and our Marine Electronics Knowledge Base for related installation guidance.
Official manuals, datasheets and brochures
Related products
- Koden TD-501T-4B – Bronze thru hull 1kW 50/200kHz 9m cable
- Koden TD-500T-3B – Bronze thru hull 600W 50/200kHz 9m cable
- Koden TD-500T-2B – Plastic thru hull 600W 50/200kHz 9m cable
Related technical resources
Before ordering Koden TD-501C+AC
Send the vessel type, hull and mounting details, echo sounder model, current transducer reference and photographs of the installation. Include the cable route and connector arrangement if known. For a fault replacement, add the symptoms and previous tests. F&C Marine can then help confirm whether TD-501C+AC is the correct 1 kW 50/200 kHz package and identify any accessories or installation work required.














Reviews
There are no reviews yet.