Description
Koden TD-501T-4B marine transducer
Koden TD-501T-4B is a bronze through-hull transducer rated at 1 kW for 50/200 kHz operation and supplied with a 9m cable. Correct transducer selection depends on the echo sounder, hull material, mounting position and intended operating requirement. F&C Marine can help confirm compatibility and installation details before the transducer is ordered or used to replace an existing unit.

Frequency, power and sounder matching
This model is listed as a dual-frequency 50/200 kHz, 1 kW transducer. Those ratings need to match the echo sounder being used; a mechanically similar transducer is not automatically electrically compatible. When replacing an existing transducer, record the exact sounder model, old transducer reference, connector and cable arrangement. If the sounder has configurable transducer settings, the correct option should be selected during commissioning in accordance with the Koden documentation.
Through-hull installation considerations
A through-hull transducer needs a position that provides a clear acoustic path and clean water flow. Avoid locations where steps, strakes, propellers, thrusters or hull fittings are likely to create bubbles and turbulence across the transducer face. Hull material and thickness need to be considered when choosing the housing and installation method. Because this version uses a bronze housing, confirm the selected position, hull construction and any material-compatibility considerations before cutting or modifying the vessel.
Cable routing and protection
The supplied 9m transducer cable should be routed where it is protected from mechanical damage and unnecessary electrical interference. Avoid tight bends, crushing and unsupported strain on the connector. Transducer cables should not be shortened, extended or altered unless manufacturer documentation permits the method used. Keep connectors dry and accessible for testing. If the route passes machinery spaces or bulkheads, plan the protection and penetrations before installation so the cable is not damaged while being pulled through the vessel.
Commissioning and performance checks
After installation, confirm that the sounder recognises the transducer and produces stable depth information. Check operation with other machinery running because electrical noise may not be present during a quiet alongside test. Where practical, assess performance with the vessel moving, as turbulence across a poorly located transducer can cause loss of bottom or unstable readings. Record the fitted transducer model, frequency, cable route and installation location for future maintenance and fault finding.
Documentation and related guidance
For Koden manufacturer information, see Koden marine electronics. Use relevant installation documentation as the final reference for hull suitability, mounting, cable handling and compatible sounders. You can also browse F&C Marine echo sounders and transducers and our Marine Electronics Knowledge Base for technical guidance.
Official manuals, datasheets and brochures
Related products
- Koden TD-501C+AC – Rubber moulded 1kW 50/200kHz with CW-840-0.3m
- Koden TD-500T-3B – Bronze thru hull 600W 50/200kHz 9m cable
- Koden TD-500T-2B – Plastic thru hull 600W 50/200kHz 9m cable
Related technical resources
Before ordering Koden TD-501T-4B
Send the vessel type, hull material, echo sounder model, existing transducer reference, photographs of the current installation and approximate cable run. If this is a fault replacement, include symptoms and checks already carried out. F&C Marine can then help confirm whether TD-501T-4B is the correct 50/200 kHz 1 kW transducer for the system and identify installation considerations before the hull is disturbed.














Reviews
There are no reviews yet.